The honeycomb mesh to be mounted on the car headlights is one of the latest innovations ready to make the hearts of all car enthusiasts and fanatics who have not discovered it beat faster.
It is a film that it is cut out and then glued directly to the car’s headlights to make it even more beautiful and particular, different from the others, without spending who knows what amounts.
This film you can buy it practically everywhere, online and in any physical store in Italy. Spending little, you can try to change the look of the car, making it much more beautiful, renewing its appearance.
Honeycomb network, that’s what it’s for
The honeycomb mesh gives an immediate 3D effect to the lights, is moldable, adapts to the curves and shapes of any previously heated headlights. The color of the honeycomb mesh is black, it has a glossy finish, it can be applied both on the front headlights, than on the rear lights, indicators or fog lights.
The honeycomb network protects the fog light or the headlights on which it has been applied, therefore its purpose is not exclusively related to aesthetics, but is also functional. Those who particularly care about their car cannot do without it.
How to apply the honeycomb mesh on the car
The first thing to do to correctly apply the honeycomb net is to clean the lights, the fog lights or indicators using a degreaser. This phase, as trivial as it may be considered, is actually important because allows you to remove any type of dirt to then stick the film perfectly, without air bubbles and dirt.
At this point we use the nebulizer, then the surface of the light, the headlight or the indicators gets wet, which will be covered with the film in the next step. Then take the honeycomb mesh and remove the protective film. The film itself is wet with water and then applied to the affected surface, passing the hands well over it. This way they go to eliminate any bubbles that can be created and making it adhere so perfectly.
If the headlight should have tight corners and therefore wrinkles should be created, just help yourself by using a hair dryer or by asking the coachbuilder for help. The latter will warm up the interested part, with his tools that are certainly more comfortable and suitable because they are professional. Finally, with a cutter, the part that protrudes is cut, trying to be careful and finish the job carefully and cleanly. Then remove the final protective film and that’s it.
